Since, my doctor recommend that I put more fiber in my diet- I decided to comply.
So… in a few hours, I will be running a few OS2 runs across my house, with 10G LR SFP+ modules.
Both runs will be from my rack to the office. One run will be dedicated for the incoming WAN connection (Coupled with the existing fiber that… I don’t want to re terminate). The other, will be replacing the 10G copper run already in place, to save 10 or 20w of energy.
This, was sparked due to a 10GBase-T module overheating, and becoming very intermittent earlier this week causing a bunch of issues. After replacing the module, links came back up and started working normally… but… yea, I need to replace the 10G copper links.
With only twinax and fiber 10G links plugged into my 8-port aggregation switch, it is only pulling around 5 watts, which is outstanding, given a single 10GBase-T module uses more then that.
Edit,
Also, I ordered the wrong modules. BUT… the hard part of running the fiber is done!
That makes sense!
I’ve never really looked into running fibre into my house.
But when I worked in a DC I laid a lot of fibre so we didn’t really think too deeply on what to use except for distance and bandwidth, unless the network team had a specific reason.
Good to know!
I have fibre to my house but only 1G so no point switching just yet.
Its not a necessity for me, however, I do lots of interesting networking experiments in my lab.
A good example, is my 40G networking project
So, this is mostly just playing around, but, it does have a few benefits. Power savings is one of them.