I recently bought my first house and I noticed some rot happening beside our garage door. It appears that when the cement driveway was poured, they got too close to the siding and now water is wicking up into the wood. I figure I can cut back the siding and replace it but how do I stop this from happening again?
Save up or arrange financing and replace all of it. Hopefully you don’t have hidden rot elsewhere…
I would replace it with something that doesn’t rot, like Hardie Sierra 8. It’s expensive, but if installed correctly it’ll last forever.
It’s ABSURDLY expensive. Just do vinyl.
Vinyl has the same curb appeal as a toothless meth addicted prostitute.
Hey! No kinkshaming!
/S
Once it’s rotted, you need to replace. This will also give you the opportunity to look at the wood behind the siding as there’s a good chance that the rot goes deeper.
You never want to have untreated wood touching concrete. Concrete will always wick water and rot the wood. When you replace the siding, leave a 3/8in gap between the wood and concrete. Seal the gap with caulk to keep water out.
I agree, just be careful with the caulk- sometimes you end up sealing liquid (or vapor) water IN instead of out. If you have good overhangs it’s probably fine but don’t do this below a window or other opening.
And for anyone wondering about concrete wicking water, look up ‘capillary break’
Replace the bottom few inches with Hardie Plank
With epoxy-based putty or paste. Take a tool and dig out as much rot as you can. There’s a two part epoxy you can get that goes on either as a paste or a putty.
For the paste, you’ll need to build it up over a few coatings. For the putty, you can form it like play-doh.
Use batons to form it or get it in rough shape and then use planers, very sharp chisels and/or sandpaper to shape it. I typical do the shaping when the epoxy is not 100% cured but rather, 60%-80%. Easier to shape.
Once in the correct shape, allow to cure and paint.
Don’t use liquid epoxy. Unless you have a 100% fool-proof seal, you’ll make a mess. Hell, you’ll probably make a mess even with one.
Good luck!
Leave a gap between the concrete and the siding, so that the water can run away/evaporate before it reaches the wood. Also make sure that the water flows away from the siding when it rains, and not up against it.
There should be a small slope away from the siding, so the water is not retained there, but leads away to avoid further damage to the siding/construction.
In Norway where I live, all houses have a clearing of 2-3 cm at least between the concrete and wood, and the floor is made so the water runs away from the building to avoid exactly this issue, because of the amount of rain and sometimes melted snow during the seasons. It’s part of the building code for houses.
Best of luck to you in getting this sorted out, make sure you get all the damaged parts out, so you avoid secret problems later on.
