I run just one Windows machine with some VMs for various services if needed. Less to maintain and have to tinker with.

I installed cable in a couple of apartments I rented. I just made it look professional and nothing was ever said about it. In one apartment town home I even had access to the attic and was able to run cable in the walls. I did have to drill through the floor and door headers in some instances, but it can be done.

I still use Dia Diagram Editor for most things. I just wish it was still being updated.

You could try gluing it and clamping but it looks like getting a clamp on it might be hard and I have not had good luck gluing veneer that is peeling away like that. That is cheap and easy to try so I would start there though. Some of the other suggestions to repair it are good as well. I will throw out another, buy a sheet of veneer and cut out a square an inch or so larger than the area that needs to be repaired. Lay the square over the area to be repaired and cut out the bad area in the shape of the repair piece, then glue the repair piece in, a little wood putty and sanding to match might do the trick.

Depending on where it is peeling away, you might try putting on small decorative trim pieces stained or painted in a complementing color. I did this all along the underside of our countertop as decoration and to make some new cabinets blend in with older existing ones.

I have “professional” drywall in my house that doesn’t look that good. Take it as the learning experience it is and rest assured that most people won’t notice it.

I put on an old pair of coveralls, gloves, hat, hood, respirator, old shoes, goggles. I covered the doorway to the room with plastic and setup a fan for ventilation and pre-heated the bottles. Even with all that I was miserable. I was hot and sweaty, had trouble breathing, and couldn’t see out of the goggles. My arms were tired and the foam mixture wasn’t always mixing properly and ended up wasting a lot of the mixture. It was still pretty expensive and time consuming… not sure I would do it again.

I thought ridge vents were all the rage these days. I installed ridge vents and then put up Reflectix Reflective Roll Insulation from the soffits up to 12-18 inches from the ridge. It reduced the heat in the attic by a noticeable amount and wasn’t too expensive or difficult to install. I also blew in additional insulation. I plan on adding additional venting in the soffits in the future. My experience is that fans fail, require maintenance, use energy, and tend to only cool the attic off in certain areas if not well planned out with supporting architecture and venting.

Crazy idea, but if you can’t get the bandwidth to support a media server like Jellyfin or Emby where you live, what about placing a server at a trusted relatives or friends house that does have access to high bandwidth? You might need/want to help offset a better internet plan for them though. You could then setup a VPN connection to be able to manage the server remotely and sync files and media to it. You could even use it for off site backup.

I don’t really know of a way that you can add insulation without taking up interior space, exterior space, or replacing the wall with more modern materials.

• What about the sides of the home not facing the street? Can you add an exterior layer of insulation and then new exterior siding to those walls?
• On the side facing the street, you could replace the stone wall with a different type of wall that was more thermally resistant. This would of course be a major undertaking.
• I am sure you have considered fully insulating the floor and ceiling as best you can.
• If rodents and or insects are a concern, look into Mineral Wool/Rockwool Insulation.

I back up everything. I use Stablebit Drivepool with duplication for all of my source code, media, photos, documents, music, books, laptop backups, etc. I back that up periodically to a Drobo DAS and 8 Bay USB enclosure setup under Drivepool. I also have off site backup (working on a new NAS which will be accessed over a VPN). I don’t want to spend the time worrying about loosing anything I have put time and effort into. Been there and done that. Drives are relatively inexpensive but can fail without warning.

After looking at other’s lists I think I am missing a good document server. Emby isn’t the best music and photo server so I could look at improving that, but it has been good enough for those purposes that I haven’t felt like going to the trouble of installing anything else.

• Aster: Multiseat software for Windows allows several users to work on the same PC.
• LaunchBox: Frontend for DOSBox, modern PC games and emulated console platforms.
• Blue Iris: Video security and webcam software
• Calibre: E-Book management and server
• Emby: Server for videos, music, audio books, and photos.
• Firewalla: VPN server, internet monitor and control
• Foundary Virtual Tabletop: Online role-playing game server.
• Grafana: Dashboard interface
• Hubitat: Home automation
• Hyper-V Manager: Tool that allows users to manage Hyper-V hosts and virtual machines (VMs)
• InfluxDB: Real-time database server.
• IotaWatt: Open WiFi electric power monitor
• Microsoft SQL Server: Database Server
• Octoprint: Web interface for 3D printers.
• PCem: Emulator for various old 8086 through Pentium PCs.
• SmartSync Pro: File sync program
• SnapRaid: Backup program for disk arrays.
• Stablebit DrivePool/Scanner: Disk pooling, file duplication, protection, disk surface scanner, and disk health monitoring
• Steam Link: Access and play steam games remotely

For the exterior of my house I use Sherman Williams Duration. It has held up really well over the last 12 years and I am still able to buy matching paint as I have only been painting walls as needed and I have time. I am only about half done :(

If I had to speculate and GUESS, based on information I know now and if I give the CTO the benefit of the doubt and assume he was competent (contrary to what I saw), I would say they were having trouble canceling the contract with the third party consulting firm we were hired through. I also think they might have been quietly moving their operations out of state to another infrastructure originally belonging to another company they bought or merged with that had their own IT team and wanted us kept out of the loop. Hiring us might have been a way to reduce our compensation and get us under an NDA regarding the move. When hiring us failed they were able to re-negotiate the terms of the contract with the consulting firm for half of what it was. Again, just a guess.

I currently use Protonmail but for some time I used hMailServer on Windows (https://www.hmailserver.com).

Similar situation. I realized my desktop that I constantly upgrade every few years was always going to be faster and more powerful than older or salvaged hardware. I now just keep it on all the time and run VMs on it as needed. Just one physical machine to maintain now! I run Aster on it so it acts as three physical machines. It is my gaming machine, my parteners gaming machine, file server, development server, database server, emulator pedestal, Emby server, Blue Iris server, and my work computer.

The trick is to add a lot of walnuts and not a lot of salmon. One piece of salmon can provide two servings this way. I consider it frugal because it is less than half the cost of fast food.

White rice cooked with an egg with a small piece of baked Salmon. Mix in some Soy sauce, Wasabi and walnuts.