So I have finally built my NAS. I used an N100 CPU because I saw it has low power consumption.
Right now I have 2 NVMe SSDs and 2 HDDs. I have installed proxmox on the 2 SSDs as RAID1. I have not partitioned the HDDs yet, they are just plugged in and powered on.
Just booting into proxmox, without any VMs or containers running, I am pulling 45W from the wall. This looks super high to me, and I’m afraid that starting to use the HDDs and running some VMs may double this…
I don’t have much references, but I have an Odroid with an external self-powered HDD, it is using 5W. I have a raspberry pi 4 with an external HDD, the raspberry is pulling 3W and the HDD 3W.
With these data, I was thinking I wouldn’t go over 20W. 45W is enormous and not something I can run 24/7, kind of a fail for a NAS…
Have I done something wrong or is it just how much it’s supposed to pull?
Edit: I have come across powertop. Using the auto tune, I was able to drop to 33-35W. I have unplugged the HDDs and dropped to 22W. I guess I cannot go lower, this may be because of the PSU or the 2 NVMe
Is that 45w a continuous draw, or is that from something that measured it while booting?
I have a small form factor Dell Optiplex with 1 NVME for the OS (Proxmox), and 3 drives (2.5" spinning disk), that idles at 10-20w. Running VM’s pushes that up to 40-50w.
And that’s still about 60-70w less than the desktop I’ve been running as a file server!
Unfortunately this is idling after boot. While booting it jumps to 70W and I haven’t seen it go below 45W idling…
Guess it’s time to disconnect some hardware and test power consumption.